Commercial Tile Repair for
Pubs, Cafés and Restaurants
A tile behind the bar rocks every time someone walks over it. In the kitchen, the grout around a few tiles near the dishwasher has started to crack and crumble. Out in the dining room, a tile edge has lifted just enough to catch a shoe. In a busy venue, none of these stay small for long. Drummy Repair provides commercial tile repair for pubs, cafés, restaurants and similar venues, re-bonding loose, hollow and drummy tiles in place by injecting a low-viscosity, structural-grade epoxy through the grout lines. There is no demolition, and the existing tiles remain in place where the repair is suitable.
Drummy Tile Repair for Hospitality Venues
Re-Bonded In Place. No Floor Rip-Out.
A drummy tile has lost its bond with the substrate underneath. The tile itself is often still in good condition. It is the adhesive bed below it that has let go, leaving a void that makes the hollow sound and can let the tile move.
Our epoxy injection system targets that void. We make small access points through the existing grout lines and inject the epoxy into the accessible voids beneath the tile, where it is intended to fill the available space and restore adhesion between the tile and the substrate. The extent of penetration and the repair outcome depend on the condition of the void, the materials involved and the site conditions. The method works on floors and walls and on a wide range of materials, including but not limited to ceramic, porcelain and natural stone.
No Demolition
No jackhammers, no tile saws and no skip bin out the front of the venue.
Your Tiles Stay
The existing tiles remain in place, so there is no hunting for a discontinued tile or batch to match.
Targeted Repairs
Only the tiles with suspected debonding are treated, rather than the whole floor.
Cost-Effective
Often a more cost-effective alternative to lifting and relaying a tiled area, where the existing tiles and substrate are suitable for repair.
Why Tiles Go Drummy in Pubs, Cafés and Restaurants
Hospitality floors work harder than almost any other tiled surface. A café or restaurant floor carries constant foot traffic through every service, and kitchens, bars and cool rooms add heavy equipment, loaded trolleys and kegs rolling across the same tiles day after day.
Kitchens and bar areas also see more water than most floors. Mopping, spills and wash-down all put moisture into the grout lines, and over time that can contribute to deterioration of the adhesive beneath the tiles. Large tiled areas near doors, windows and alfresco openings heat up and cool down with the weather. On top of that, a floor laid without full adhesive coverage under each tile can carry voids from day one.
None of this means a hollow tile is a moisture problem, or that the floor is failing. Tapping can help identify suspected debonding, but the cause and extent require assessment. Our guide to what causes hollow sounding tiles covers the common causes in more detail.
Where We Repair Tiles in Hospitality Venues
Commercial Kitchens
Kitchen floors take heavy equipment, constant traffic and regular wash-down. We re-bond drummy tiles across prep areas, cooking lines and dish areas. Where water pools on the floor or water ingress is suspected, we encourage a professional assessment on site before any tile repair, because pooling water can point to a drainage, falls or waterproofing issue that needs to be addressed first. Our kitchen tile repair page explains why kitchen floors in particular go hollow.
Bars and Service Areas
Behind the bar, tiles carry staff traffic, dropped glassware, heavy fridges and kegs. Loose tiles here can be re-bonded without pulling out the joinery that sits on them.
Dining Rooms and Entries
Front-of-house floors are where customers notice a lifted edge or cracked grout. Re-bonding keeps the existing look of the floor, which matters when the tiles are part of the fit-out.
Alfresco Areas and Courtyards
Outdoor dining areas take sun, rain and furniture being dragged across them every day. Our outdoor tile repair page goes into why outdoor tiles lift and go hollow.
Bathrooms and Walls
We repair drummy tiles on floors and walls in customer and staff bathrooms. Areas with pooling water need an on-site assessment first.
Who We Work With
Venue Owners and Operators
Pubs, cafés, restaurants, bars, clubs and similar venues dealing with loose or hollow tiles in their own premises.
Property Managers
Managers of commercial and retail properties with hospitality tenants, who need tiles repaired with as little disruption to the tenant as possible.
Builders
Builders working on new fit-outs and renovations where tiles have gone drummy.
Our Commercial Tile Repair Process
Contact & Quote
Send us photos or a short video of the affected tiles. In most cases we can quote from that. Where the scope needs it, or where water ingress is suspected, we come out to the venue, sound out the area to map the tiles with suspected debonding, and give you a clear quote covering the solution, timing and cost.
Schedule & Prepare
Once the quote is approved, we book a time with you and let you know the simple prep steps, which are usually just clearing furniture and equipment off the area being repaired.
Epoxy Injection Repair
Our technicians make small access points through the grout lines and inject the epoxy into the voids beneath the tiles. Because there is no demolition, only the area being repaired needs to be kept clear. Most jobs are completed in approximately a day or two, depending on scope, and your technician will confirm timing for each job.
Completion & Care
We check the repaired area and let you know when the floor is ready for normal use. The time required before the area can be used will depend on the epoxy curing requirements, site conditions and scope of work. Your technician will confirm when the floor is ready. Access points in the grout may require finishing or minor touch-ups.
When Tile Repair Isn't the Right Solution
Epoxy injection is intended to restore adhesion to tiles that are still intact. If a tile is cracked, chipped or broken, injection will not put it back together, and that is not a job we do.
Injection also does not repair a failed waterproofing membrane, correct drainage or falls, or fix a substrate that has failed or is still moving. Where water pools on the floor or water ingress is suspected, those issues should be assessed and addressed by the appropriate trade before deciding whether tile re-bonding is suitable. While injection can help restore adhesion, the long-term outcome depends on the condition of the substrate, the extent of debonding and whether any underlying issues have been addressed. No repair can guarantee that the problem will not return.
Repair or Re-Tile a Venue Floor?
Re-tiling a section of a commercial floor means breaking out the old tiles, grinding off the adhesive, sourcing new tiles and laying them, with that part of the venue out of action for the duration. Then there is the match. Commercial fit-outs often use a specific tile range, and once that range is discontinued, a patch of new tiles in the middle of the floor stands out.
Where the tiles are intact and the substrate is suitable, re-bonding can be a more cost-effective alternative to re-tiling, while retaining the existing tiles and reducing disruption to the venue. Our guide on how to fix loose tiles: repair or replace compares the two in more detail.
More About Commercial Tile Repair
Frequently Asked Questions
Do you repair tiles in pubs, cafés and restaurants?
Yes. We repair loose, hollow and drummy tiles in hospitality venues and other commercial properties, as well as homes. The quickest way to start is to send us photos or a short video of the problem area.
Can you repair drummy tiles in a commercial kitchen?
Yes, where the tiles are intact and the substrate is suitable. Where water pools on the floor or water ingress is suspected, we encourage a professional assessment on site first, because injection restores adhesion but does not fix a drainage or waterproofing problem.
Will the repair be visible?
Access points are made in the existing grout lines, not through the tiles. The method avoids tile demolition, although access points in the grout may require finishing or minor touch-ups.
How long will the repaired area be out of use?
Most jobs are completed in approximately a day or two, depending on scope. The time required before the area can be used will depend on the epoxy curing requirements, site conditions and scope of work. Your technician will confirm when the floor is ready.
How much does commercial tile repair cost?
It depends on how many tiles are affected, the tile type, the area and the site conditions. Repair is generally the more economical option, because it avoids demolition, waste removal, new tiles and re-laying. Send us photos or a short video and we will give you a no-obligation quote.
Should I fix a drummy tile straight away?
An unsupported tile may be more vulnerable to damage, such as cracking under a dropped keg or a loaded trolley, and once a tile cracks it can no longer be re-bonded. A lifted edge can also be a trip hazard for staff and customers. An assessment can help determine whether action is needed.
Ready to Fix the Tiles in Your Venue?
Got loose or hollow tiles in your pub, café or restaurant? Send us photos or a short video for an accurate quote, or call 0436 329 569 to book an inspection. Drummy Repair was founded by a Master Tiler with over 20 years of experience and holds QBCC Licence No. 15566319. We repair commercial tiles across Brisbane, the Gold Coast, the Sunshine Coast and Logan.